Create a Segmented Sweep

Create a segmented sweep by setting 2 sweep parameters and sketching a path with arcs.

The parameters affect only arcs in the path. The minimum number of segments for a sweep is 2.

For information about using sweeps in families, see Creating Family Geometry.

1. In the Family Editor, begin creating a sweep.
2. On the Properties palette, under Other, select the check box for Trajectory Segmentation.
3. Enter a value for Maximum Segment Angle. Valid values are between 0 and 360 degrees.
4. Sketch or pick a path with arcs.
5. On the Mode panel, click (Finish Edit Mode) to complete the path.
6. Create a profile or use a pre-loaded profile.
7. On the Mode panel, click (Finish Edit Mode) to complete the sketch of the sweep.

Tip: You can change a segmented sweep to a non-segmented sweep by clearing the check box for Trajectory Segmentation.

Sample segmented sweep with 30 degree Maximum Segment Angle.