AMRECTQLY (Command)

Creates a square using the midpoint of the height as the starting point and specifying half of the base.

Find

List of Prompts

The following prompts are displayed.

Specify Height Middle Point

Specifies the midpoint of a vertical side of the square.

Specify Half Base

Defines the width of the square by specifying the distance from the midpoint of a horizontal side to the nearest corner. If you enter a negative value, the horizontal side extends to the left.

Corner

Draws a rectangle when you specify two diagonally opposite corners.

Base

Draws a rectangle when you specify the midpoint of the base and a corner on the opposite side.

Height

Draws a rectangle when you specify the mid point of the height and a corner on the opposite side.

Center

Draws a rectangle when you specify the center of the rectangle and a corner.

Chamfer

Creates a rectangle with chamfered corners.

Use existing

Uses the values displayed on the command prompt as the chamfer lengths.

Setup

Displays the Chamfer dialog box, which enables you to specify the chamfer lengths to use.

Fillet

Creates a rectangle with filleted corners.

Use existing

Uses the value displayed on the command prompt as the fillet radius.

Setup

Displays the Fillet dialog box, which enables you to specify the fillet radius to use.

Centerline

Creates a rectangle with centerlines.

Base

Draws a centerline parallel to the base.

Height

Draws a centerline parallel to the height.

Both

Draws centerlines parallel to the base and height.