Use these settings for extruding polygons in Interactive Manipulation mode.
-
Select an Edit Poly or editable poly object. >
Modify panel > Polygon sub-object level > Edit Polygons rollout > Extrude > 
(Settings)
-
Select an Edit Poly or editable poly object. > Polygon sub-object level > Quad menu > Tools 2 quadrant > Extrude > (Settings)
-
Select an Edit Poly or editable poly object. > ribbon > Modeling tab > Polygon Modeling panel >
(Polygon) sub-object level > Polygons panel > Shift+click 
(Extrude) or choose Extrude Settings from the drop-down list.
Interface
Extrude Polygons uses the caddy interface when Enable Caddy Controls is on; when off, the standard settings dialog is used. For details on using the caddy controls, see The Caddy Interface.
Left: the caddy interface; Right: the standard dialog
- [Extrusion Type]
-
From the drop-down list, choose the method for extruding multiple polygons at once:
-
Group Extrusion takes place along the average normal of each contiguous group of polygons. If you extrude multiples of such groups, each group moves along its own averaged normal. -
Local Normal Extrusion takes place along each selected polygon's normal. -
By Polygon Extrudes each polygon individually.
-
-
Extrusion Height -
Specifies the amount of the extrusion in scene units. You can extrude selected polygons outward or inward, depending on whether the value is positive or negative.
_____
-
OK -
Applies the settings to the current selection and closes the caddy. Keyboard equivalent: Enter
-
Apply and Continue -
Applies the settings to the current selection, retaining them for the preview if you then change the selection. Keyboard equivalent: Ctrl+Enter
-
Cancel -
Closes the caddy without applying the settings to the current selection. Does not reverse previous uses of Apply And Continue. Keyboard equivalent: Esc