To Draw Lines

1. Click Home tab Draw panel Line. Find
2. Specify the start point and end point of the line segment.
3. Continue specifying additional line segments.

   To undo the previous line segment, enter u at the prompt. Click Undo on the Quick Access toolbar to cancel the entire series of line segments:

   
4. Press Enter or Esc to end the command, or enter c to close a series of line segments.

Draw a Line at a Specific Angle

1. Click Home tab Draw panel Line. Find
2. Specify the start point.
3. Do one of the following to specify the angle:
   • Enter the left angle bracket (<) and the angle, for example <45, and move the cursor to indicate the direction.
   • Move the cursor to indicate the angle.
4. Do one of the following to specify the length:
   • Click a point to specify the endpoint without using object snaps. Trim or extend the resulting line as needed.
   • Enter the length of the line, for example 2.5.