To Work with Section Views

Slice through model to display half, quarter, or three-quarter views.

Create a section view to see inside your model. A section view does not modify geometry.

Use a planar face or plane to slice away a portion of a model temporarily.

Section views can be saved in design view representations.

After you select a section view, you can right-click and select Flip to cycle through available views. Quarter and three-quarter views can show the opposite view.

To move a section plane, right-click and select Virtual Movement Section Plane 1 (or Section Plane 2). Then drag the section plane, set its offset, or rotate the mouse wheel.

Note: Both the quarter or three-quarter section view allow selection of any two planes, not just perpendicular planes. You can define the type of section cut and display sectional slices, if desired.

Create a Half Section

1. Click View tab Appearance panel Half Section View .
2. Select any plane or planar face as the cutting plane.
3. Right-click and select Flip, if necessary, to change the direction of the section.
4. Drag the plane or enter a value in the field to change the position.
5. Click Continue.
6. Right-click then select:
   • OK to apply the section.
   • Flip to change the direction of the section.
   • Virtual Movement > Section Plane 1 to change the position of the plane.

Create Quarter and Three-Quarter Sections

1. Click view tab Appearance panel and then select a section view type:
   • Quarter Section
   • Three Quarter Section
2. Select any plane or planar face as the first cutting plane.
3. Right-click and select Flip, if necessary, to change the direction of the section.
4. Drag the plane or enter a value in the field to change the position.
5. Click Continue.
6. Select any plane or planar face as the second cutting plane.
7. Right-click and select Flip, if necessary, to change the direction of the section.
8. Drag the plane or enter a value in the field to change the position.
9. Click Continue.
10. Right-click then select:
    • OK to apply the section.
    • Flip to change the direction of the section.
    • Three Quarter Section View to change the section view type.
    • Virtual Movement Section Plane 1 or Section Plane 2 to change the position of the plane.
      Note: In Inventor, components created from Content Center are not sectioned by default. Check the Section All Parts box on the Assembly tab in the Application Options to section Content Center parts. Click Tools tab Options panel Application Options to access the Application Options.

Revert to Normal View

• Click View tab Appearance panel End Section View . The model returns to the normal view.