To Add Ducts and Conductors to Segment Cross Section

Cross sections are added to the map automatically when you assign a segment model to a segment. If the segment already has a model assigned, the cross section is replaced. Create ducts and conductors by clicking snap points in the cross section.

To add ducts and conductors using segment cross section templates

1. Open the Electric Explorer.
2. Create a segment and assign a segment model.

   In the Segment container, select the segment and select a model from the Model drop-down list.

   You can also right-click the Segment in the container. Click Show Form. On the General tab, use the Model drop down to specify the number of ducts in the segment. Click Update & Close.

3. In the Segment container, select the segment.
4. In the Duct container, click New Duct. In the drawing, click the snap point for the duct. Assign the duct model.
5. Select the duct, and in the Conductor container, click New Underground Conductor.
6. In the cross section, click the snap point in the duct. You can place as many conductors in the duct as snap points are defined. When the maximum number of conductors has been created, as message appears.

To delete a segment cross section

• Select any of the cross section features, and click Delete.