Fill+Pack Analysis Advanced Options dialog

This dialog is used to specify the Fill+Pack analysis related advanced options for the selected analysis sequence.

To access this dialog, ensure that you have selected an analysis sequence that includes Fill+Pack, click (Home tab > Molding Process Setup panel > Process Settings), if necessary click Next one or more times to navigate to the Fill+Pack Settings page of the Wizard, then click Advanced options.

General settings

Note: Some of these entries are molding process dependent, and appear only when you select the appropriate molding process.

Widget	Explanation
Molding material	Select and edit the material to analyze. Click Edit to make changes to the selected material.
Process controller	Select and edit a process controller to control the injection molding process during the analysis. Click Edit to control the filling phase, velocity/pressure switch-over point, pack/holding phase, mold temperature and mold-open time.
Injection molding machine	Select and edit an injection molding machine to simulate your molding machine during the analysis. Click Edit to configure the injection unit, hydraulic unit, and clamping unit.
Mold material	Select and edit the mold material to be used during the analysis. Click Edit to specify the density, specific heat, and thermal conductivity of the mold material.
Solver parameters	Select and edit the solver parameters to be used during the analysis. Click Edit to configure intermediate results, mold/melt convergence criteria, and analysis restart settings.