Use the Fill Hole page to create mesh elements on any surfaces of the model where there are holes in the mesh.
Note: The Fill Hole page applies only to Dual Domain meshes.
Dialog elements
- Diagnostics display
- Shows the number of defects that were found in the model.
The type of defect depends on which page of the Wizard you are using.
- Show diagnostics
- Displays a graphical representation of the diagnostics results.
- Show model
- Displays the model only (with no diagnostics). Tip: Select the Show model check box, and then toggle the Show diagnostics check box on and off for a good indication of what the Mesh Repair Wizard is reporting.Note: If you close the Mesh Repair Wizard with the Show model check box deselected, the model will not be visible. To make the model visible again, click
(). - Fix
- Fixes any defects found by the Mesh Repair Wizard for the current page (without moving to the next page).
- Back
- Goes back to the previous page of the Wizard.
- Next
- Fixes any defects found by the Wizard for the current page, and moves forward to the next page.
- Skip
- Moves forward to the next page of the Wizard (without fixing any defects).
- Close
- Closes the Wizard (without fixing any defects).
- Finish
- Fixes the defects on all pages of the Wizard and moves to the Summary page.
- Status bar
- Shows the number of defects that were fixed on the current Wizard page.