The Set Property dialog enables you to define a particular model property for the selected molding process.
This dialog can be used to define:
- A coolant inlet for a Cool analysis.
- An inlet for rapid heating and cooling of the mold.
- A gas entrance for a Gas-assisted Injection Molding analysis.
- A multiple-barrel reactive molding controller for a Multiple-Barrel Reactive Molding analysis.
- A hot gate pressure controller for a Dynamic Feed system.
- Whether material A or material B is injected at a particular injection location for a Co-injection analysis.
- Venting analysis location properties for a 3D analysis of a Thermoplastics Injection Molding, Thermoplastics Overmolding, Reactive Molding, or Microchip Encapsulation molding processes. At least one venting analysis location should be set on the model when the option to Perform venting analysis is selected.
- Dispensing controller properties for a 3D Underfill Encapsulation analysis when the option to Perform dynamic analysis is selected.