To access this dialog, open the Thermocouple controlled cooling inlet dialog, select Time with target temperature for the Valve control method, and click Specify
| Property | Description |
|---|---|
| Switch off time | Enter the time in seconds, following injection, at which the control valve of the cooling channel should be turned off. |
| Switch on time | Enter the time in seconds, following injection, at which the control valve of the cooling channel should be turned on. |
| Temperature control | This section of the dialog refers to the temperature at which the valve should be maintained, and the node at which the temperature is measured. |
| Target temperature | Enter the temperature at which the valve should be maintained. |
| Thermocouple node | Enter the ID of the thermocouple node, at which the temperature is measured. |
| Cycle control | If the thermocouple node in the mold has not reached the target temperature, you can choose to extend either the mold open or the mold close time.
If you select the Do not delay injection option, then the thermocouple settings are ignored and the specified injection times are followed. |