Create the Welds

We will create the upper weld as Part 3 and use the Mirror command to create the lower weld.  The lines of the lower weld will then be modified to place them in Part 4.

1. Click Draw Draw Line.
   • Type 3 in the Part: field.
2. Draw three line segments forming the upper weld, as follows:
   1. Click at the left end of the upper horizontal line on the horizontal part (Point A in the image below).
   2. Activate the Use Relative check box.
   3. Type 1 in the DZ: field and press Enter, creating line AB.
   4. Type 1 in the DY: field, type -1 in the DZ: field and press Enter, creating line BC.
   5. Click on point A, creating line CA.  
   6. Press Esc once to end the chain of line segments but leaving the Line command active.
   
3. Draw a construction line about which the weld will be mirrored, as follows:
   1. Click the construction vertex at the center of the large hole.
   2. Type -10 in the DY: field and press Enter to create the mirror line.
   3. Click Esc twice to exit the Line command. The mirror line appears as shown below.
   
4. Click and drag the mouse to draw a selection rectangle enclosing only the upper weld objects.
   1. Select  Draw Pattern Mirror.
   2. Click Pick.
   3. Click the mirror line that was just created.
   4. Click OK to mirror the weld.
   Note: The new copy of the weld is currently selected. We will next change the part number for these lines while they are still selected.
5. Click Draw Modify Attributes.
   1. Type 4 in the Part: field.
   2. Click OK.
6. Click on the horizontal line that was used to mirror the weld.
7. Holding down the Ctrl key, click and drag to draw a selection rectangle around the construction vertex at the left end of the mirror line, selecting it also.
8. Click Tools Clipboard Delete. Since this line does not belong to any of the part outlines, it must be removed before the 2D mesh can be generated. Note that you can also press the Delete key, rather than using the ribbon command.

   The model should display as shown in the following image.

   

   Tip: As an alternative procedure, if you prefer to keep the mirror line, create it as Part 5 in step 3. Since Part 5 would not be a valid 2D part outline, simply deactivate this part to exclude it from the upcoming 2D mesh generation process and subsequent analysis.

Next