Use the options in the
Cutting Depth area to specify the cutting depths and plunge clearance.
- Start Depth — Enter the depth (Z) from the surface of the material at which you want to create the drill holes.
- Finish Depth — Enter the depth (Z) of the bottom of each drill hole.
- Plunge Clearance — The tool will make a rapid move down to this clearance above the material, then drill at the plunge rate. The plunge rate is defined in the
Tool area after you have selected a tool.
- Tool — Click
Select to select the tool you want to use using the
Tool Database dialog. When you select the tool, click the control bar showing the name of the tool to display its parameters. To change the selected tool, click
Select again.