|
Format |
Description |
|---|---|
|
Drill |
This program format specifies the header block for a drilling cycle. |
|
Spot Face |
The header block for a spot face cycle is specified via this format. |
|
Deep Hole |
A deep hole cycle header block is determined with this format. |
|
Chip Break |
This format specifies the header block for a chip break cycle. |
|
Tap |
This format specifies the header block for a tapping cycle. |
|
Bore (F-F) |
The header block for a boring (feed-in, feed-out) cycle is specified with this format. |
|
Bore (F-D-F) |
A boring (feed-in, dwell, feed-out) cycle header block is specified via this format. |
|
Bore (F-S-R) |
A boring (feed-in, stop spindle, rapid) cycle is specified with this format. |
|
Bore (No Drag) |
This format specifies a boring (feed-in, stop spindle, move to side, retract) cycle. |
|
Back Bore |
This format specifies a back bore cycle. |
|
Hole Milling |
This format specifies a hole milling cycle, for example G208. |
|
Canned Move |
This format specifies the format of canned cycles, following their initial definition. |
|
Cycle Cancel |
This format specifies the cycle cancel block for any of the canned cycles. |