Install Inventor LT on a Single Computer

To automate the installation of the software on multiple networked computers, see Inventor LT Deployments.

For general information on installation, refer to the Workflow: Basic Product Installation topics. For specific Inventor configuration information, refer to the topics in this section

1. Prepare for installation:
   • Follow the guidelines in About Installation Prerequisites.
   • Apply relevant service packs to the operating system.
   • Disable anti-virus software.
2. Start the Inventor LT installation program.

   For instructions, see the topics under Workflow: Basic Product Installation.

3. Configure the Inventor stand-alone options:

   Access: On the Install > Configure Installation page, you see a triangular control for access to a configuration panel: Click anywhere in the product box to open a configuration panel.

   • Autodesk Inventor LT
     • Sub-components

       The Configurator 360 add-in to Inventor provides the capability to upload designs directly from Inventor to Configurator 360.

   • A360 desktop
     • Autodesk 360 lets you connect your Autodesk product with Autodesk 360 web services, and gives you the option to synchronize your online files with your local computer.

       Autodesk 360 is available as a shared component in the installer. It can be deselected to prevent its installation, or it can be installed in a disabled state, to be enabled later.