Roughing
If the Toolpath attribute is set to Turning, the normal roughing passes are enabled. Each roughing pass is cut in the same direction.
Feed straight down into the part. The distance is based on the depth of cut.
Cut down the right-hand wall.
Feed straight across.
Feed up the left-hand wall.
Withdraw from the wall, retract all the way across the feature.
Finishing
If the Toolpath attribute is set to Turning, the toolpath is generated as shown below.
The tool traces the contour of the feature from right-to left.
The tool is withdrawn from the part based on withdraw angle and withdraw length.