The following table shows the available analysis sequences, and the mesh type required for that analysis sequence.
Thermoplastics injection-compression overmolding is supported by the following mesh types:
3D
and by the following analysis sequences, where those at the top of the list use injection compression in the first shot, and those at the bottom of the list use injection compression in the second shot.
| Analysis sequence | Mesh type |
|---|---|
|
Fill (Inj-Compression) |
|
|
Fill + Pack (Inj-Compression) |
|
|
Fill + Pack (Inj-Compression)+ Overmolding Fill |
|
|
Fill + Pack (Inj-Compression) + Overmolding Fill+ Overmolding Pack |
|
|
Fill + Pack (Inj-Compression) + Overmolding Fill + Overmolding Pack + Warp |
|
|
Fill + Pack + Overmolding Fill (Inj-Compression) |
|
|
Fill + Pack + Overmolding Fill + Overmolding Pack (Inj-Compression) |
|
|
Fill + Pack + Overmolding Fill + Overmolding Pack (Inj-Compression) + Warp |
|