The following table shows the available analysis sequences, and the mesh type required for that analysis sequence.
This molding process simulation is supported by all mesh types:
Midplane
Dual Domain
3D
| Analysis sequence | Mesh type |
|---|---|
| Fill |
|
| Fill + Pack |
|
| Fill + Pack + Overmolding Fill |
|
| Fill + Pack + Overmolding Fill + Overmolding Pack |
|
| Fill + Pack + Overmolding Fill + Overmolding Pack + Warp |
|
| Cool (FEM) |
|
| Cool (FEM) + Fill + Pack + Overmolding Fill |
|
| Cool (FEM) + Fill + Pack + Overmolding Fill + Overmolding Pack |
|
| Cool (FEM) + Fill + Pack + Overmolding Fill + Overmolding Pack + Warp |
|
You can also run a Fiber orientation analysis by selecting the corresponding options in the Process Settings Wizard.