Use the Fill Hole page to create mesh elements on any surfaces of the model where there are holes in the mesh.
Note: The
Fill Hole page applies only to Dual Domain meshes.
| Dialog element | Explanation |
|---|---|
| Diagnostics display | Shows the number of defects that were found in the model.
The type of defect depends on which page of the Wizard you are using. |
| Show diagnostics | Displays a graphical representation of the diagnostics results. |
| Show model | Displays the model only (with no diagnostics).
Tip: Select the Show model check box, and then toggle the Show diagnostics check box on and off for a good indication of what the Mesh Repair Wizard is reporting.
Note: If you close the Mesh Repair Wizard with the
Show model check box deselected, the model will not be visible. To make the model visible again, click
 ().
|
| Fix | Fixes any defects found by the Mesh Repair Wizard for the current page (without moving to the next page). |
| Back | Goes back to the previous page of the Wizard. |
| Next | Fixes any defects found by the Wizard for the current page, and moves forward to the next page. |
| Skip | Moves forward to the next page of the Wizard (without fixing any defects). |
| Close | Closes the Wizard (without fixing any defects). |
| Finish | Fixes the defects on all pages of the Wizard and moves to the Summary page. |
| Status bar | Shows the number of defects that were fixed on the current Wizard page. |