To check for, or set, mesh aggregation in a 3D Warp analysis

Mesh aggregation reduces the computational time of a 3D warp analysis.

1. Open your study.
2. Click (Home tab > Molding Process Setup panel > Process Settings).
3. Click Next one or more times until the Warp Settings page appears.
4. Confirm that the Warpage analysis type is set to Small deflection, which is the default setting.
5. Confirm that Use mesh aggregation is selected. This is the default setting.
6. Click OK to accept the changes, or Cancel to exit without any changes.
7. Click Finish.