Use the
Solids Verification Options dialog to specify how
PartMaker verifies toolpaths in the Solids window.
To display this dialog, select
Part Features > Solids Verification Options.
The following options are available on the
Solids Verification Options dialog:
Show Tool as:
- Solid — Displays a solid representation of the cutting tool if the
Verification Delay is set to 1 or higher.
- Do not show tool —
PartMaker does not display the tool while verifying the toolpath(s) on the solid model.
Stock Motion Verification — Select to visualise the motion of the stock when verifying a toolpath in the Solids window.
Note: This option is available only for
PartMaker/SwissCAM.
Section Guide Bushing — Select to visualise a sectioned guidebushing. If deselected, the guidebushing is visualised as a fully revolved solid.
Note: This option is available only for
PartMaker/SwissCAM.
Show Toolpath —
PartMaker displays toolpath lines while verifying toolpath(s) on the solid model.
Verification Delay(0-9) — Enter a number between 0 and 9 to control the speed of the verification, with 0 being the fastest and 9 the slowest.