Use this dialog box to select the alignments and specify chainage ranges for the Incremental Chainage report.
This report lists northing, easting, and straight information for a range of alignment chainages, based on a specified chainage increment.
Specifies the alignments to include in the report. Select a check box to include the alignment.
Displays the name and description of the alignments in the drawing.
Displays the start and end chainages for a selected alignment
You can edit these values by highlighting an alignment in the list and adjusting the Report Settings (see below).
Displays the start and end chainages for a highlighted alignment. Click an alignment name in the list to highlight it.
You can edit these values to change the range of chainages included in the report. You can enter formatted or unformatted values, such as 2+50.95 or 250.95.
Specifies the chainage increment to use. For example, specify 50 to report at increments of 50 feet or meters along the alignment.
The increment is applied to all alignments. Chainage 0+00 is always included in the report. Odd chainages are not included if they do not match the chainage increment. For example, if the increment is 50, and the alignment starts at chainage -10+00, the report will begin at chainage 0+00. However, if the alignment begins at chainage -60+00, the report will begin at chainage -50+00.
Specifies the name and location of the resulting report.
Generates the report and saves it to the specified location.
Closes the dialog box and discards changes to chainage ranges.