Use this procedure to edit or remove a wall sweep from an individual wall. You can change the component the sweep is applied to. You can also change the miter angles at each end of the sweep and the offsets in the wall.
- Double-click the wall you want to change.
- On the Properties palette, expand Advanced, and expand Worksheets.
- Select the setting for Sweeps.
- Select a wall sweep, and change its settings:
If you want to … Then … change the profile used to define the geometry of the sweep select a different profile for Profile. apply the sweep to a different wall component select a different component for Component. change the miter angles at each end of the wall enter different values for Start Miter and End Miter. offset the sweep within the wall enter a value for Offset Within. vertically offset the sweep enter a value for Offset Vertical. delete the sweep from the wall component click 
. - Click OK.