To Specify Cleanup for Individual Walls

Use this procedure to specify the following cleanup settings for one or more walls:

• Whether the wall cleans up with other walls.
• The cleanup group for the wall.
• Whether the justification line position corresponds to the center line of the wall or to the wall justification.
• The cleanup circle radius for both ends of the wall, or separate values for the start and endpoints of the wall.

1. Select the walls you want to change, and double-click one of them.
2. On the Properties palette, expand Basic, and then expand General.
3. Turn wall cleanup on or off:

   If you want to …	Then …
   turn off wall cleanup so that the walls do not clean up with any other walls	select No for Cleanup automatically. If you select this option, you do not need to specify other settings.
   turn on wall cleanup and specify cleanup settings	select Yes for Cleanup automatically, and proceed to step 4.

4. Select a cleanup group definition.

   The walls will clean up with other walls that also belong to the cleanup group definition that you select.

5. Expand Advanced, expand Cleanups, and expand Cleanup Radius Overrides.
6. Specify the cleanup circle radius for the walls:

   If you want to …	Then …
   specify the same cleanup circle radius for the start and endpoints of the walls	enter a value for Cleanup radius, and verify that No is selected for Override start cleanup radius and Override end cleanup radius.
   specify a cleanup circle radius for the start point of the walls	select Yes for Override start cleanup radius, and enter a value for Start cleanup radius.
   specify a cleanup circle radius for the endpoint of the walls	select Yes for Override end cleanup radius, and enter a value for End cleanup radius.

   Start and End are based on the direction the wall was drawn. If you enter zero for any cleanup circle radius, the wall justification lines need to touch for the walls to clean up with other walls.