To Edit a Slab/Roof Slab Body Modifier in Place

Use this procedure to edit the shape of a body modifier that is attached to a slab or a roof slab.

You can edit the body using grips to edit faces, using Boolean commands to add or remove other objects from the body modifier, and other editing commands to change its shape.

1. Select the slab or roof slab that has the body modifier you want to change.

   A temporary mass element is created for you to edit the geometry of the body modifier. If the slab or roof slab contains multiple body modifiers, a mass element is created for each body modifier. If an object was not originally a mass element (for example, if you used a structural member as a body modifier), the object becomes a temporary Free Form mass element with faces that you can edit.

   Note: After you perform an editing task from the Edit in Place contextual tab, you may need to select a profile again to perform another editing task. If you do not see the editing commands that you expect on the contextual tab, re-select a profile to redisplay the Edit in Place contextual tab.
2. Edit the body modifier.

   If you want to …	Then …
   change the shape of a body modifier that is a Free Form mass element	select the body modifier. Select a Face grip to activate edge grips for the face. Move the grips to the desired locations. Continue editing other faces in the same manner.
   change the shape of a body modifier that is a conventional mass element	select the body modifier. Select grips and move them to change the shape of the body modifier. The grips that are available depend on the type of mass element used as a body modifier and the current view direction.
   add an object to a body modifier	place the object in the location where it is needed. Select the object, and press Enter. Enter y (Yes) to keep the object in the drawing, or press Enter to erase it.
   subtract an object from a body modifier	place the object in the location where it is needed. Select the object, and press Enter. Enter y (Yes) to keep the object in the drawing, or press Enter to erase it.
   create a body modifier that is the intersection of the original body modifier with another object	place the object in the location where it is needed. Select the object, and press Enter. Enter y (Yes) to keep the object in the drawing, or press Enter to erase it.
   trim a body modifier	specify the points that define the trim plane, and select the side of the body modifier to be trimmed. The trimmed body modifier is converted to a Free Form mass element.
   divide the face of a body modifier into two faces	specify the points that define the edge created by splitting the faces.
   join two faces that are on the same plane into a single face	select the edge that separates the coplanar faces.
   remove a body modifier	select the object that forms the body modifier, and press Delete.

3. Save or discard the changes.