To Specify Gap Between the Center Mark and its Centerlines

Control the gap between the center mark and its centerlines.

Specify the Default Gap Between a New Center Mark and its Centerlines

1. At the Command prompt, enter CENTERCROSSGAP.
2. Specify a new value. You can enter any of the following:
   • Relative value - any positive real number followed by x.
   • Absolute value - any positive real number
   • ByLineType

Specify the Gap Between an Existing Center Mark and its Centerlines

1. If the Properties window is not displayed, select any object. Right-click and select Properties.
2. Select one or more center marks.
3. In the Properties window, under Geometry, select Cross Gap.
4. Specify a new value.