Displays a window within the Block Editor to test a dynamic block.
You can only use the BTESTBLOCK command in the Block Editor. With the Test Block window you can test a dynamic block without closing the Block Editor. You can test dynamic grips or display the Properties palette and test the behavior when changing the properties. You can also insert additional copies of the block to test the insertion behavior. You can make changes and test the block without saving the changes to the block definition.
In the Test Block window, all AutoCAD commands operate the same way except the BEDIT, SAVE, SAVEAS, and QSAVE commands. The BEDIT command is not available in Test Block window. The SAVE , and QSAVE commands remove the Test Block status from the window and the Test Block window becomes an open drawing. A Close Test Block Window contextual panel is added to the ribbon when you are in the Test Block mode.
In the Block Editor, the BCLOSE, BTESTBLOCK, and CLOSE commands automatically close the Test Block window and discard the temporary file. The BTESTBLOCK command closes the current Test Block window and opens a new window with the current definition.