Creates a filled circle or a wide ring.
Find
A donut consists of two arc polylines that are joined end-to-end to create a circular shape. The width of the polylines is determined by the specified inside and outside diameters. If you specify an inside diameter of 0, the donut is a filled circle.
The following prompts are displayed.
- Inside Diameter
-
Specifies the inside diameter of the donut as shown.
- Outside Diameter
-
Specifies the outside diameter of the donut.
- Center of Donut
-
Specifies the location of the donut based on its center point. A donut is drawn at each point specified until you press Enter to end the command.
