-PDFATTACH (Command)

Attach a PDF underlay from the command line.

When you attach a PDF file as an underlay, you link that referenced file to the current drawing. Any changes to the referenced file are displayed in the current drawing when it is opened or reloaded.

Tip: You can drag a PDF file into the drawing area to start the PDFATTACH command.

The following prompts are displayed.

Path to PDF File to Attach

Accepts the full path and file name for the PDF file to be used as an underlay.

Entering a tilde (~) displays the Select PDF File dialog box (a standard file selection dialog box).

You can specify the path and PDF file name as follows:

pathname\filename.pdf

or

“pathname\filename.pdf”

If you enter a valid PDF file name without a file extension, the program adds the extension and searches for the file.

Enter Page Number

Enter a page number. For a list of pages, enter ?.

Enter Page(s) to list <*>

Lists the pages available in the PDF file in a separate text window.

Insertion Point

Specifies the insertion point for the selected PDF file.

Scale Factor

Specifies the scale factor of the selected PDF underlay and the scale factor units.

If INSUNITS is set to “unitless” or if the underlay does not contain resolution information, the scale factor becomes the underlay width in AutoCAD units. If INSUNITS has a value such as millimeters, centimeters, inches, or feet, and the underlay has resolution information, the scale factor is applied after the true width of the underlay in AutoCAD units is determined.

Rotation

Specifies the rotation angle of the selected PDF underlay.