Specifies the cycling order of the grips that could be used as the insertion point for the dynamic block reference.
BCYCLEORDER (Command)
When inserting a dynamic block reference in a drawing, you can use the Ctrl key to cycle through the grips that have cycling turned on in the block definition. The selected grip is used as the insertion point for the block reference.
The following options are displayed.
- Grip Cycling List
-
Lists the grips in the dynamic block definition. A check mark in the cycling column indicates that cycling is turned on for that grip.
- Move Up
-
Moves the selected grip up in the cycling order for the dynamic block reference.
- Move Down
-
Moves the selected grip down in the cycling order for the dynamic block reference.
- Cycling
-
Turns cycling on or off for the selected grip. A check mark in the cycling column indicates that cycling is turned on for that grip.