Note: To rotate cable tray runs in model views, make sure the current display configuration uses a Cable Tray Model display representation for both cable trays and fittings. Only these display representations show an open side to cable trays and fittings, as is necessary to visually represent their rotation. If you are using the U.K. profile or the Global profile, the drawing templates are configured to use these display representations by default. If you are using another profile, you must configure the current drawing to do so, and you might also need to run LOADMETRICCMDS beforehand to make the display representations available in Display Manager. For information on loading the module, see Using Other Profiles.
To rotate a cable tray run
- Select an isometric view direction, such as SW Isometric.
- Select a cable tray, right-click, and click Rotate Cable Tray Direction.
This action rotates the segment or fitting 90 degrees.
- Repeat the previous step as required.
- Select the same segment or fitting, right-click, and click Regenerate Cable Tray System.
- Specify how you want to rotate connected objects:
| If you want to apply the same rotation angle to all connected in-line objects... |
Then... |
|---|
| in the system |
enter n (no). |
| to next transition in both directions |
enter y (yes). |