To Modify the Layout of a Flexible Duct

You can modify the layout of a flexible duct run.

1. Select the flexible duct segment.
2. In the Properties palette Advanced Geometry, click the left or right arrows to toggle to the desired location along the spline.
   Note: This procedure uses the spline segment mode.
3. Specify values for the X, Y, and Z vertices.

For flexible ducts drawn using any of the segment modes (line, arc, or spline), you can use grips to move the location of control points.

1. Select the flexible duct segment.
2. Select the location grip to move the segment to a new location.

Tip: Click the location grip and then the Ctrl key once to maintain the connection with the MvPart. Click the location grip and then the Ctrl key twice to break the connection.