This one-pick selection method for Line and Polyline tools vectorizes a raster line with a single click.
AutoCAD Raster Design toolset automatically corrects the resulting line to conform to current drafting settings. The following sequence of decisions applies:
- If AutoCAD SNAP is active, the start point and the endpoint are snapped to the grid. No other correction is performed.
- If AutoCAD SNAP is inactive but OSNAP is active, AutoCAD Raster Design toolset adjusts points that are within the tolerance defined in the Correction Tolerance section on the VTools General tab of the Raster Design Options dialog box. If both ends of the line are osnapped, no further correction is performed.
- If OSNAP is inactive, or at least one point was not osnapped, AutoCAD Raster Design toolset determines if POLAR or ORTHO snap is active. If so, AutoCAD Raster Design toolset aligns the line by moving the endpoint. If one point was snapped earlier, then the free end is automatically considered the endpoint. AutoCAD Raster Design toolset adjusts the angle about the start point without changing the length. The angle snap occurs only if the new endpoint falls within the tolerance distance.
- If Round Values is enabled, the line length is rounded to the precision specified on the VTools General tab of the Raster Design Options dialog box.
For more information about adjusting SmartCorrect settings, see General VTool Settings.