To Drive Forwards on an Arc

  1. Move the cursor in front of the vehicle and pause. A ghosted image will show the path the vehicle will travel from the last position through the target point (the cursor).If you cannot see a vehicle you may have your drawing units set incorrectly.
    Tip: If you cannot see a vehicle you may have your drawing units set incorrectly.

    A straight red line connecting the cursor to the last position indicates that you are requesting a maneuver that cannot be performed; the error will be displayed in the bottom left corner of the AutoCAD status bar. Try moving the cursor to perform a less severe turn.

  2. Move the cursor until the vehicle is in the desired position and left click to confirm. A vehicle outline will be drawn at the selected location and you can now repeat the process for the next position.

    The AutoDrive Options dialog allows you to specify a minimum radius and to change settings for the current turn. See below.

  3. To turn tight and then travel straight, select Drive Onto Bearing.