AddWallBreaklines Method (WallBreaklineCreationData[], Double, Double, Double, Double)

Adds wall breaklines to a surface, specifying a single elevation for all vertices.

Namespace: Autodesk.Civil.DatabaseServices
Assembly: AeccDbMgd (in AeccDbMgd.dll) Version: 13.4.208.0

Syntax

C#

public SurfaceOperationAddBreakline AddWallBreaklines(
	WallBreaklineCreationData[] creationData,
	double midOrdinateDistance,
	double maximumDistance,
	double weedingDistance,
	double weedingAngle
)

Visual Basic

Public Function AddWallBreaklines ( _
	creationData As WallBreaklineCreationData(), _
	midOrdinateDistance As Double, _
	maximumDistance As Double, _
	weedingDistance As Double, _
	weedingAngle As Double _
) As SurfaceOperationAddBreakline

Visual C++

public:
SurfaceOperationAddBreakline^ AddWallBreaklines(
	array<WallBreaklineCreationData>^ creationData, 
	double midOrdinateDistance, 
	double maximumDistance, 
	double weedingDistance, 
	double weedingAngle
)

Parameters

creationData: Type: Autodesk.Civil.DatabaseServices.WallBreaklineCreationData[]
An array of WallBreaklineCreationData objects that define breakline entities, offset side and the elevation value for each vertex, used to create wall breaklines.

midOrdinateDistance: Type: System.Double
When the breakline is defined from a polyline with curves, the midOrdinateDistance value is used to tessellate the arcs in the polyline.

maximumDistance: Type: System.Double
Specifies the maximum distance between vertices. If the distance between vertices on a breakline is greater than the maximumDistance, then points are added along the breakline at equal intervals that are less than or equal to the maximumDistance.

weedingDistance: Type: System.Double
The distance value for the weeding factor.

weedingAngle: Type: System.Double
The angle value for the weeding factor.

Remarks

Set a parameter to 0 to ignore it.