Use this dialog box to apply parameter mapping to structures in existing pipe networks so that they have the parameters that are required for the Analyze Gravity Network command.
Parameter mapping is required only for parts created with Part Builder. Parts created with the Infrastructure Parts Editor already have the parameters that are required for the Analyze Gravity Network command.
This command works on the current pipe network catalog.
Note: Using this command may change the properties of structures in existing pipe networks.
- Apply Mapping to All Fields of All Parts in Existing Pipe Networks
- Specifies that the mapping configuration is applied to all fields even if they already have a value specified.
- Apply Mapping to Empty Fields Only
- Specifies that the mapping configuration is applied only to fields which do not already have a value specified.
- Mapping Configuration
- Opens the
Drainage Structure Parameter Mapping Configuration dialog box, which you can use to set up the parameter mapping for the current pipe network catalog.