To Create a Survey Figure Vertex Using a Bearing and Distance

Create a new vertex in a specified direction from the current figure vertex. At least one vertex must exist in the figure for this command to work properly.

1. In Toolspace, on the Survey tab, right-click a named network Survey Command Window.
2. At the Command line, enter:

   FIGURE BRG-DIST [bearing] [quadrant] [distance]

Command Line Example

BEG BFIG

FIG NE 1000 1000

FIG BD 61.1111 1 30.480

AZIMUTH: 61.1111 DISTANCE: 30.4800

NORTH: 1014.6902 EAST: 1026.7063

END

The following illustrates the Figure Bearing Distance command:

Command Syntax

FIGURE BRG-DIST [bearing] [quadrant] [distance]

Command Synonym

FIG BD

Parameter	Definition
bearing	The desired bearing. Enter this value in the current survey database angular units, either DMS, grads, decimal degrees, mils, or radians.
quadrant	Specify the quadrant using one of the following numbers: 1 (for NE), 2 (for SE), 3 (for SW), or 4 (for NW).
distance	The measured distance from the current vertex to the new vertex. Enter this value in the current survey database distance units.