Create Sample Lines - From Corridor Stations Dialog Box

Use this dialog box to create sample lines along an alignment for specified corridor stations.

General

Alignment: Displays the name of the currently selected alignment associated with the range of stations.

Station Range

From Alignment Start

Specifies whether the station range starts at the beginning of the alignment (that is, at the station located at the beginning of the alignment):

True: Begins the station range at the start of the alignment.
False: Specifies the beginning station in the range. Enter or pick a beginning station.

Start Station

Specifies the beginning station in the range. Enter a station value directly or click to pick from the drawing. Available if From Alignment Start is False.

To Alignment End

Specifies whether the station range ends at the end of the alignment (that is, at the final station along the alignment):

True: Ends the station range at the end of the alignment.
False: Specifies the ending station in the range. Enter or pick an ending station.

End Station

Specifies the end station in the range. Enter a station value directly or click to pick from the drawing. Available if To Alignment End is False.

Left Swath Width

Snap To An Alignment

Specifies that the sample line snaps the swath widths to an offset alignment at each station:

True: Snaps the widths to an offset alignment at each station.
False: Does not snap the widths.

Alignment

Specifies the currently selected alignment. Available if Snap To Alignment is True.

Note: Although all alignments in the current drawing are listed, do not select the parent alignment. The resulting length will be zero.

Width

Specifies the swath width to the left of the alignment, using the actual ground units. Enter a positive value in ground units. Available if Snap To Alignment is False.

Right Swath Width