This selection constructs an
arc with a specific center and radius with the starting and ending points determined by angles.
- Select Construct tab > Geometry panel > Arc > Center Radius Start End to enter arc-creation mode.
- Enter the radius in the
R field.
- Pick or enter the location of the center point.
- Enter the
Begin Angle in degrees. This angle is measured counter-clockwise from horizontal.
- Enter the
End Angle in degrees.
If the
Relative option is deselected, the angle is absolute measured counter-clockwise from horizontal. If the
Relative option is selected, the angle is measured relative to the
Begin Angle.
- Click
Create to create the arc.
- When you have finished creating arcs,
exit arc mode.