Select an option to determine how the tape name is set when importing clips. Disabled if Sequence Detection from the Clip Options menu is set to Frames.
Select: | To: |
---|---|
Enter Tape Name |
Activate the Tape Name field where you enter the tape name. When selecting multiple files for import, this tape name is used for all imported files. |
Tape Name from File Name |
Use the name of the imported file as the tape name. |
Tape Name from Directory |
Determine the tape name from the detected directory structure. Use the Level field below to configure the relative path to the directory from which the tape name can be determined. |
Although available for all types of files, the Level field is intended for directory structures output by film scanners. A typical image file directory structure looks like this: ./<tape>/<resolution>/clip.######. In this case, selecting Levels Up 2 in the Level field identifies the directory that corresponds to the tape name (./<tape>). Enabled if Tape Name is set to Tape From Directory.
The Default Resolutions table uses a frame's height and width to assign it an aspect ratio, a scan mode, and a frame rate. You can find the Default Resolutions table in
. It is also used when restoring legacy archives.Select how the clip is named when the file is imported.
Select: | To: |
---|---|
Enter Clip Name |
Activate the Clip Name field so that you can manually enter the clip name. When selecting multiple files for import, this name is used for all imported files. |
Clip Name from File Name |
Use the name of the imported file as the clip name. |