Specifies the tolerance class and fit class in Involute Spline Connection Generator.
|
Access: |
Ribbon: Design tab  Power Transmission panel Involute Splines. In the Involute Spline Connection Generator, click  next to the Length edit field. |
|
OK |
Confirm the selection and close the dialog box. |
|
Cancel |
Closes the dialog box. |
|
Centering to Groove Sides |
|
|
Set the tolerance grades for shaft and groove. |
|
|
Test Dimensions Settings |
|
|
User |
Check the box to enter the user values. If the box is not checked, the values are calculated according to the appropriate standard. |
|
Pin Diameter, Shaft |
Pin diameter on the shaft. |
|
Finishing of Flanks |
|
|
Select the way the grooves on the shaft and hub are created. |
|