Adds a chamfer on an edge of the shaft section. You can add only one chamfer on the shaft edge.
You can insert a chamfer either on the left or on the right of the selected shaft section.
Note: For an already created chamfer, you cannot change the method how the chamfer was created.
- Access
- Ribbon: Design tab
Power Transmission panel Shaft. On the Design tab, select Cylinder in the tree control. In the First edge features or Second edge features drop-down menus, select Chamfer 
.
Method
Specifies how the chamfer is constructed.
- Distance
- Creates a chamfer with the same offset distance from the edge on both faces. Selects a single edge, multiple edges, or chained edges. Corner setback appearance may be specified.
- Distance and Angle
- Creates a chamfer defined by an offset from an edge and an angle from one face to the offset. Any edge or all edges of a selected face may be chamfered at once.
- Two Distances
- Creates a chamfer on a single edge with a specified distance for each face. Edges may be chained together.
-
- Confirms the component's input.
-
- Closes the dialog box.