Use this dialog box to specify the block to use to create nodes and centroids in the resulting dissolve topology.
- Point Object for Centroid Creation
-
Specify the block used to represent centroids.
- To select from a list of block definitions in the drawing set, click the down arrow.
- To create centroids from a block saved as a DWG file, click Browse. Select the file to use.
- To create centroids a point, leave the box blank or enter ACAD_POINT.
- Point Object for Node Creation
-
Specify the block used to represent nodes.
- To select from a list of block definitions in the drawing set, click the down arrow.
- To create nodes from a block saved as a DWG file, click Browse. Select the file to use.
- To create nodes as a point, leave the box blank or enter ACAD_POINT.
- Cancel
-
Close the dialog box without performing the dissolve.
- Back
-
Display the previous dialog box.
- Next
-
Disabled because this is the last dialog box in the list.
- Finish
-
Dissolves the topology using the current settings. The Finish is available after you specify the dissolve parameter and enter a valid topology name.