Use this dialog box to specify the block to use to create nodes and centroids in the resulting overlay topology.
- Point Object for Centroid Creation
-
Specify the block used to represent centroids.
- To create centroids using using a block defined in the drawing set, click the down arrow and select a block from the list.
- To create centroids using a block saved as a DWG file, click Browse. Select the file to use. This inserts the entire DWG as a single block.
- To create centroids as a point, select ACAD_POINT.
- Point Object for Node Creation
-
Specify the block used to represent nodes.
- To create nodes using a block defined in the drawing set, click the down arrow and select a block from the list.
- To create nodes using a block saved as a DWG file, click Browse. Select the file to use. This inserts the entire DWG as a single block.
- To create nodes as a point, select ACAD_POINT.
- Load
-
Use settings that you previously saved.
- Save
-
Save the current settings so you can use them again.
- Cancel
-
Close the dialog box without performing the topology overlay.
- Back
-
Display the previous dialog box.
- Next
-
Disabled because this is the last dialog box in the list.
- Finish
-
Perform the topology overlay using the current settings. The Finish is available after you select the overlay topology and enter a valid topology name for the resulting topology.