Topology Overlay Analysis - Output Topology dialog box

Use this dialog box to specify settings for viewing the resulting overlay topology onscreen.

You can specify the name, description, and layer for the new topology.

Highlight

Show the results of the analysis on screen using the color specified in the Color.

Color

Select the color you want to use to highlight the results of the analysis in the map. To clear the color when you finish viewing the results in the map, at the Command prompt, enter redrawall.

Name

Enter a unique name for the new topology. Topology names can contain letters, numbers, and the underscore and hyphen characters.

Description

Enter a description for the new topology.

Layer

Specify a layer for the new topology. To select from a list of layers in the current drawing, click the down arrow. To create a new layer, type the name in the box.

Load

Use settings that you previously saved.

Save

Save the current settings so you can use them again.

Cancel

Close the dialog box without performing the topology overlay.

Back

Display the previous dialog box.

Next

Click to display the Topology Overlay Analysis - Output Attributes dialog box

Finish

Perform the topology overlay using the current settings. The Finish is available after you select the overlay topology and enter a valid topology name for the resulting topology.