Trimming removes (actually hides) any region of a surface that is bounded or bisected by a curves-on-surface. Trimming a surface lets you create complex edges and holes in NURBS surfaces. You must create curves-on-surface before you can trim the surface.
Trim a surface
- Choose Surfaces > Trim Tool.
- Click the surface you want to trim.
A “trim grid” appears on the surface.
- Click the regions (defined by curves-on-surface) of the surface you want to keep (you do not need to hold Shift to click multiple regions).
As you click, regions that will be trimmed away are dotted, and regions that will be kept are solid.
If you want to change the tool so you click the parts of the surface you want to trim off, open the option box (Surfaces > Trim Tool >
) and set
Selected State to
Discard.
- Press Enter to trim.
Tip:A seam can divide a region in two. Make sure when you click a region bisected by the seam that both sides are marked.
Untrim a surface
- Select the surface or surfaces you want to untim.
- Choose
Surfaces > Untrim.
The default is to remove all trims from the surface, restoring it to its original state. To only reverse the most recent trim operation, open the option box (Surfaces > Untrim >
) and set
Untrim to
Last.
If you turned on the Shrink Surface option when you trimmed the surface, Untrim cannot restore the original shape of the surface.
Notes
- If a NURBS primitive cone or cylinder with cap(s) is to be involved in a subsequent trimming operation, they must be created with the Extra transform on caps option set to on, or the surface for trim will only be selectable in the Outliner/Hypergraph and not in the view.