PowerMill 2022.0.2 update
The fixes in PowerMill 2022.0.2.
| Toolpaths |
| A problem has been fixed that caused PowerMill to gouge the part when Approach from outside was enabled in a Slice Rest Area Clearance toolpath. PMILL-15885
|
| A problem has been fixed with Flat Slice Area Clearance toolpaths with multiple cuts, where the toolpath was often missing the final profile pass on all the multiples of the base flat slices, when using the Raster style. When using the Offset Model style, the toolpath would sometimes fail to offset from part of the model on the multiples of the base flats. PMILL-15795
|
| A problem has been fixed that could cause PowerMill to close unexpectedly when calculating a Raster Flat Finishing toolpath. PMILL-15904
|
| A problem has been fixed that could result in collisions going undetected when using a negative thickness on model components. PMILL-9837
|
| A problem has been fixed that slowed the initial scanning of the model when calculating 3D Offset Finishing, Constant Z Finishing, Steep and Shallow Finishing, and Raster Finishing toolpaths. PMILL-16018
|
| A problem has been fixed that could result in unnecessarily fragmented passes in the steep passes of a Steep and Shallow Finishing toolpath when using the Exclude Flats option. PMILL-15521
|
| A problem has been fixed that slowed the calculation of 3D Offset Finishing toolpaths. PMILL-15414
|
| Drilling |
| A problem has been fixed where certain single component holes could not be drilled where the top was defined as Component. PMILL-13204
|
| A problem has been fixed that could cause helical drilling to gouge with simple holes. PMILL-15827
|
| Customer error reporting (CER) |
| A problem has been fixed that could cause PowerMill to close unexpectedly when using Flat Slice Area Clearance. This issue was identified by CER. PMILL-15869, PMILL-15807
|
| A problem has been fixed that could cause PowerMill to close unexpectedly when using Tool Axis Smoothing. This issue was identified by CER. PMILL-15876
|
| A problem has been fixed that could cause PowerMill to close unexpectedly when using a shank component enclosed within a holder component. This issue was identified by CER. PMILL-15950
|