To finish a route at an open port

1. This procedure begins with pipe routing in-progress.

   If you are not at the Specify Next Point prompt do the following:

   • On the ribbon, click Home tab Part Insertion panel Route Pipe.
   • In the drawing, click to specify a start point.
   
2. Hold down SHIFT and right-click in the drawing area, click Node.
3. Move your mouse over an open port. Click the Node object snap.
   

   If a path to the open port cannot be found, you cannot continue this procedure. You can use precision placement to align the pipe route with the port (For example: route the pipe to a matching elevation) and start this procedure again.

4. If multiple solutions are available do the following:
   • At the command prompt, enter n (Next).
     
   • Continue pressing ENTER until the solution that you want to use displays.
   • At the command prompt, enter a (Accept).