Modify instance properties to change an individual soffit's level, offset, slope, and more.
To change instance properties, select the element and change its properties on the Properties palette.
| Name | Description |
|---|---|
| Constraints | |
| Level | Specifies the level on which to place the soffit. |
| Height Offset From Level | Sets the height of the soffit above or below the level where it is being sketched. |
| Room Bounding | If selected, it means the soffit is part of a room boundary. If not selected, it means the soffit is not part of a room boundary. This property is read-only before creating a soffit. After you draw the soffit, you can select it and then modify this property. |
| Dimensions | |
| Slope | Changes the value of the slope-defining line to the specified value, without the need to edit the sketch. The parameter initially displays a value if there is a slope-defining line. If there is no slope-defining line, the parameter is blank and disabled. |
| Perimeter | Indicates the perimeter of the soffit. |
| Volume | The volume of the soffit. This is a read-only value. |
| Area | The area of the soffit. This is a read-only value. |
| Identity Data | |
| Comments | Comments about the roof soffit. |
| Mark | A label applied to roof soffits. Usually a numeric value. This value must be unique for each soffit in a project. Revit LT issues a warning if the number is already used but allows you to continue using it. You can see the warning using the Review Warnings tool. See Reviewing Warning Messages. |
| Phasing | |
| Phase Created | The phase when the soffit was created. |
| Phase Demolished | The phase when the soffit was demolished. |