To Fillet a Wall Endcap Component

Use this procedure to modify a wall endcap by filleting a wall component.

  1. Select the wall segment with the wall endcap to modify.
  2. Click Wall tabEndcap panelEndcap Edit In Place.
  3. Select the component that has the corner you want to fillet.

    You may only fillet the corner of one component at a time. Press Esc to clear component selection.

  4. Click Edit In Place tabModify panelFillet.
  5. Specify the fillet radius.
  6. Select the first component edge to fillet.
  7. Select the second component edge to fillet.
  8. Save or discard your changes:
    If you want to... Then...
    Save any changes you made during the edit-in-place session as a new style click Edit In Place tabEdits panelSave As.
    Discard any changes you made during the edit-in-place session click Edit In Place tabEdits panelCancel.
    Save any changes you made during the edit-in-place session click Edit In Place tabEdits panelFinish.

    In the following example, a brick veneer corner is filleted.