Use the Select Graph dialog box to calculate bending moments, torsion moments, and stresses in the part (shaft, or axle) you selected with the AMSHAFTCALC Command.
|
Bend tab Specifies the bending moment diagrams and deflection diagrams to draw. |
|
|
Torsion tab Specifies the torque related diagrams to draw. |
|
|
Stresses tab Specifies the stress related diagrams to draw. |
|
|
Placement Defines where to draw the graphs. If required, you can move the graphs after they are created by dragging them by their grips. |
|
|
Under Shaft Places the graphs directly below the shaft contour you performed the calculation on. The scale for the x-axis is 1:1. |
|
|
One Point Places the graphs at a point you specify. The system places the diagrams one below the other starting from the point you specify. |
|
|
Window Places the graphs inside a window you specify. The system automatically selects a scale for the x and y axes, based on the available space. If the window you specify is not large enough to fit the graphs, the system displays a warning message and returns to the dialog box. |
|
|
Select all Selects all graphs in the Bend, Torsion and Stresses tabs. |
|
|
Unselect all Clears any selections specified in the Bend, Torsion and Stresses tabs. |
|
|
Table Title Specifies a title for the result block. |
|